PC CHIPS P23G (V1.0) User's Guide download pdf (Page 14)

Chapter 2: Motherboard Installation

Installing Memory Modules

This motherboard accommodates two 184-pin DIMM DDR1-2 sockets (Dual

Inline Memory Module) for unbuffered DDR400/333 memory modules (Double

Data Rate SDRAM) and two 240-pin DIMM DDRII1-2 sockets (Dual Inline

Memory Module) for unbuffered DDR2 533/400 memory modules (Double

Data Rate SDRAM). DDR SDRAM is a type of SDRAM that supports data

transfers on both edges of each clock cycle (the rising and falling edges),

effectively doubling the memory chip’s data throughput. You must install at least

one module in any of the four slots. Each module can be installed with 256 MB

to 1 GB of memory; total memory capacity is 2 GB.

G. Make sure the CPU fan is plugged to the

CPU fan connector. Please refer to the

CPU cooling fan user’s manual for more

detail installation procedure.

Note 1: To achieve better airflow rates and heat dissipation, we suggest

that you use a high quality fan with 3800 rpm at least. CPU fan and

heatsink installation procedures may vary with the type of CPU fan/

heatsink supplied. The form and size of fan/heatsink may also vary.

Note 2: The fan connector supports the CPU cooling fan of 1.1A~2.2A

(26.4W max.) at +12V.

Note 3: DO NOT remove the CPU cap from the socket before installing a

CPU.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 52 53

No comments

PC CHIPS P23G (V1.0) User's Guide Page 14